READ THESE INSTRUCTIONS CAREFULLY, HERE ANSWERS TO ALL QUESTIONS
TURNING ON: Hold button 5 until the beep sounds, then enter the password.
The password is entered using buttons 1 (1st and subsequent digits), button 2 (confirmation of each dialed digit), Only 10 entry attempts, after which
the appliance will block if it is incorrectly dialed.
Button5—- short-switching modes, long-on-off device, hold up to peak-on-off back light
Button4 — short-switching memory banks, long-switching frequencies 315-433
Button3 —- short on-off reception, long-erase. Hold in an empty bank until the first peak, this is the inclusion of the mode – block re-code-
Button2—- short-open, long-catch-up of the code, if in an empty bank with the reception turned on for a long time, then enter the menu of control modes
in this menu 2 button briefly select the modes, and 1 button briefly turn them on or off, exit the control menu by holding 2 button.
Button3 —- short-close, long-open trunk, if in an empty bank with the reception on for a long time, then the input-output is in three operating states,
Only 1.5 and 6 modes will work.
if you need to save any of the signals, you just need to go to another memory bank BRIEFLY by pressing button4 And then the signal is automatically
will be saved in the cell in which it was caught.
Mode management – for many users it’s not convenient to switch a bunch of modes that they don’t use for a while, so there’s
the decision to turn on exactly those modes that are needed, and the others to be temporarily turned off, this is done by holding 2 button in an empty bank, while
the red light comes on, by short pressing on 2 button select unnecessary modes, and turn them off by 1button, or turn them on when the mode is turned off
the box opposite the digit of the selected mode disappears, after selecting the active modes, you need to exit the menu of mode selection by also holding 2 button.
after which only those modes that were selected will work! There is also an emergency switch from 7 modes to 3 modes with one touch,
– if in an empty bank with the reception on hold 1 button, then 3 modes will turn on — that’s 1.5.6 …. Also, by holding 1 button, you can exit 3 operating modes!
SECURITY — Home mode function. Received signal at 10 cell when the device is turned off, works with the car whose signal was recorded
in this cell.
For convenience, using the switching modes, each press on kn-5 is accompanied by vibrating, and when turned on 7 mode, double vibrating, so that
it was more convenient to count the modes without seeing the key chain!
Shutdown: Hold button5 <> until vibration is triggered.
NOTE: explanations of what is re-code lock! The same signal recorded in the memory cell is not recorded a second time, but accompanied
a short signal, meaning that this signal already exists in some of the memory cells! Power is enough for 4.5 hours of work. Recorded signals
in different modes, you can use to open while in any of the modes. Reception of full-time trinkets, especially VAG and FORD, are accepted stably
not further than from 15 meters, and from 20-25 meters – unstable
ATTENTION! The manufacturer is not responsible for the likelihood of a complete blockage of the device, since blocking can only occur through fault
user with ten times the wrong password. In this case, the device cannot be restored, replaced or returned. Also not subject
replacement, return and repair in case of attempt to open the rear cover of the key fob.
PS.
ALWAYS CHOOSING THE DISTANCE FOR THE SCAN OF THE CAR, DO NOT FORGET THAT IN STATE KEYS THE OWNERS RARELY CHANGE THE BATTERY AND ON THIS
WHEN CLOSING A CAR WITH A SEATED BATTERY, THE SIGNAL DOES NOT FLY AWAY, SO WHEN IT IS PREFERRED TO BE IN THE NEAR AUTO SCAN
Kia Quoris (checked for 2014 keys and 2017 smart)
KIA CERATO GT 2019-20 YEAR
KIA SID 2007-20 YEAR
KIA K-3 GT 2019-20 YEAR
KIA FORTE GT 2019-20 YEAR
Hyundai Santa Fe 2001-2019
Weight 0,05 kg
ALL DEVICES ARE SOLD FOR OFFICIAL USE ONLY!!!
IF YOU USE THEM FOR ANY ILLEGAL PURPOSES, THIS IS YOUR OWN RESPONSIBILITY!!!